FIRST DUAL MOTOR ESC

Picture the functionality and utility of two Novak Goat Crawler Speed Controls in brushed mode and Novak¡¦s Dig Unit; now, envision it in one highly programmable, inexpensive speed control and you get the revolutionaryM2 Dig 3S Dual Brush ESC (#1846). This patent-pending, new controller combines 6 adjustable parameters with its revolutionary performance including a separated drag brake and dig function.

With only the addition of two brushed crawler motors, the M2 Dig controls both motors and performs dig maneuvers. In addition to the standard Dig Mode, the M2 features a Proportional Dig Mode which allows you to dial-in partial Dig Power on the fly for even finer control and precise maneuverability through tricky terrain. It also features an exceptional control on steep inclines and descents. Plus, the built-in electronic Dig Power is independently adjustable from the Hill/Drag Braking. This truly unique speed control supports both 2S and 3S LiPo!

Because of its unique features, the M2 Dig 3S is perfect for the new Axialc XR10™! The M2 Dig 3S ESC / Dual Terra Claw Brush Motor Combo (#1845) is matchless when used in Motor-On-Axle vehicles, exceeding the performance of traditional two-system setups. The M2 ESC is also compatible with other dual-MOA vehicles, such as EnRoute'sR Berg™, Integy'sR Super and Unlimited Class of crawlers, and Clod BusterR-based vehicles.

A SPECIALIZED DIG
The compact M2 Dig ESC is easy to install and operate. There are three fully programmable throttle profiles: Dig Mode, Proportional Dig Mode and Single Output Mode.

The M2 Dig 3S ESC  installed in an Axialc XR10™.

Single Output Mode is for applications with single motors or operation without a 3-channel transmitter. In this mode all four motor power wires can be soldered to one brush motor for higher performance, or connect two motors and control them both at the same time.

In addition to crawling applications, the M2 Dig 3S ESC is ideal for applications that require two motors, such as robots, boats, tanks and submarines.
¡@

The M2 Dig 3S ESC can be fine tuned via Novak¡¦s fully adjustable PC interface, the NovaLink™ (#5440). The NovaLink software is  purpose-built for crawling.

ON-BOARD AND PC ADJUSTABILITY 
The M2 Dig not only gives racers three separate throttle profiles, but can also be easily adjusted via Novak's reliable on-board setup. There are four PCB-mounted LEDs to aid in programming and two different colored external LED indicator lights, located at the ends of six inch harnesses that visibly display when a motor is locked and the vehicle is ready to dig.

This new ESC can also be fine-tuned with the optional NovaLink Programming Interface (#5440), Novak's fully adjustable PC interface. The downloadable software for the M2 Dig is purpose-built for crawling and assists in adjusting the speed control's programmable features. This software, as well as updates, will be available from Novak's website to NovaLink owners.

The powerful speed control also comes equipped with instant reverse via Novak¡¦s Zero Reverse Delay, which provides immediate power delivery in both forward and reverse directions.

The M2 Dig 3S ESC includes two different-colored external LED indicator lights that visibly display when a motor is locked.

NO MODIFICATIONS NECESSARY 
Like Novak¡¦s Electronic Dig Unit (#5450), the M2 Dig 3S ESC does not require any vehicle modifications to install or operate. Simply plug it into any three-channel surface receiver, and you¡¦re ready to crawl! This ESC is not only easy to install into a vehicle, but it possesses countless features on its own! Compared with a Dual ESC setup, the M2 allows racers to use top of the line crawling technology with just one speed control.

The M2 Dig 3S ESC is easily programmed into most three-channel transmitters, such as the SpektrumR DX3R DSM2 3CH Surface Radio™, Airtronics'R M8 and M11 R/C Radios™, and a TraxxasR (TQ-3) Transmitter™*

M2 DIG 3S ESC/DUAL TERRA CLAW BRUSH COMBO FEATURES Fully programmable, user-friendly interface with five adjustable parameters: Drag Brake (10 settings), Dead Band (5 settings), Minimum Drive (10 settings), Drive Frequency (10 settings) and Battery Type Selection (3 settings ¡V Li-Po, Li-Fe and NiMH) Three throttle profiles: Dig Mode, Proportional Dig Mode and Single Outpu Mode Independently powers the front or rear motors in a dual-motor crawler vehicle Operates on both 2S and 3S applications Instant reverse via Novak's Zero Reverse Delay providing immediate power delivery in both forward and reverse. Compatible with optional NovaLink (#5440) for expanded programming and ability to download firmware updates to the ESC Internal high-voltage 5-Amp Linear BEC Universal JST Input Plug for Ch.2 and Ch. 3, which fits all popular brand receivers Water-resistant case with gasket seal Thermal Overload Protection Features a set of power output pins for running cooling fans, auxilary lights, scale winchces, etc. Meets RoHS compliance and includes 120-Day Warranty Designed and assembled by Novak in Irvine, Calif., using globally-sourced components   M2 DIG 3S ESC/DUAL TERRA CLAW BRUSH COMBO SPECS Input Voltage: 2-3 Li-Po/Li-Fe cells or 4-9 NiMH cells (1.2V/cell) On-Resistance (dual motor): 0.0016 ohm. at 25 degrees C trans. temp. On-Resistance (single motor): 0.0008 ohm. at 25 degrees C trans. temp. ESC Footprint: 1.16" x 1.47" (29.5 x 37.3 mm) ESC Weight (w/o wires): 1.30 oz. (36.9g) Motor Limit: 27-turn (Single), 33-turn (Dual) 540-sized dual brushed motors BEC: 6.0 volts DC / 5.0 amps Status LEDs: 4 on-board; 2 external Voltage Cut-Off: 6.25V (2S Li-Po), 9.38V (3S Li-Po) (Automatic) Power Wires: 14G Super-Flex Copper-Strand Silicone Wire   REPLACEMENT / OPTIONAL PARTS #5315 (optional) or #5320 (replacement) User-replaceable Input Harness #S5346 Plug-In LEDs for M2 Dig and Dig Module (replacement) #5440 NovaLink™ PC Programming Interface (optional) #5463 3-Amp High-Voltage Universal BEC (optional) #5508 14-Gauge Silicone Brushless Wire Set (replacement) #5602 Power Programming Switch (replacement) #5626 Glitch Buster Capacitor (optional) #5647 & 5651 Black Cooling Fan 25x25x10mm (replacement) #5682 Power-Cap Harness (replacement) #5686 Power Trans-Cap Module - 3S LiPo (optional) #5731 Low-Loss Power Connectors ¡V 3.5mm (optional) #5831, 5832 & 5833 Lead-Free Silver Solder (optional) #5840 & 5841 Mounting Tape 25 x 35mm (optional) #5850 & 5851 Remote Programming Switch ¡V Hardwired (optional)

* The TraxxasR (TQ-3) Transmitter™ must be modified with a three-position auxiliary switch to operate with the M2.

Berg™ is a registered trademark of EnRouteR. IntegyR and Clod BusterR are registered trademarks. DX3R DSM2 3CH Surface Radio™ is a registered trademark of SpektrumR. M8 and M11 R/C Radios™ are registered trademarks of AirtronicsR. TQ-3 Transmitter™ is a registered trademark of TraxxasR. M2 Dig 3S Dual Brush ESC™, Terra Claw Crawling Brush Motors ¡V 55T and Novalink™ are registered trademarks of Novak Electronics, Inc.R.